Author Topic: Basement Stairway Cabinets  (Read 429 times)

0 Members and 1 Guest are viewing this topic.

Offline shanegrilah

  • Posts: 36
Basement Stairway Cabinets
« on: June 21, 2020, 02:16 PM »
Finally finished these cabinets above my basement stairway. Couldn't find a picture of what it looked like before I started but is was basically a blank wall with a door narrow door the width of one stud cavity for access. Unfinished on the inside and poorly insulated. Knocked the pictured hole in, insulated and put some drywall in but didn't do any finishing as it is all unseen. Seemed like a good place to put a wall oven.

All soft maple used is from trees in my parents back yard. Didn't do a lot of wood editing so all the character flaws are left in. Counter top and lower door panels are maple, teak, black walnut and red oak that I was given. Sunburst panel is maple, cherry and teak. Lots of separate glue ups.

Regards,
Shane

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline ear3

  • Posts: 4042
Re: Basement Stairway Cabinets
« Reply #1 on: June 21, 2020, 02:56 PM »
My lord, that takes the checkerboard to another level.  Do you have any process picks of the lamination/glue up steps you used to arrive at that pattern?  Really, really marvelous work.  Did you do the spiral legs yourself?
Kapex KS 120 w/UG Cart and Extensions • CXS Set • T18+3 w/Centrotec Installer's Set • PDC 18/4 • TS 75 • TSC 55 • HKC 55 w/250, 420 and 670 FSK rails • Carvex 420 w/Accessory Kit • Domino 500 Set • Domino 700 XL • OF 2200 w/Base Accessory Kit • OF 1400 • OF 1010 • MFK 700 EQ Set • LR 32 • MFS 400 w/2000, 1000, and 700 extensions • Rotex 90 • Rotex 150 • LS 130 • ETS-EC 150/5 • ETS-EC 150/3 • Pro 5 LTD • RTS 400 • RAS 115.04 • RS 2 • HL 850 • Vecturo OS 400 • AGC 18-115 • CT 26 w/BT module • CT Sys w/Long-Life Bag • MFT/3

Offline shanegrilah

  • Posts: 36
Re: Basement Stairway Cabinets
« Reply #2 on: June 23, 2020, 05:52 PM »
@ear3

Edward,

The legs are from Adams Wood Products.

I only have pictures of the 3D cube log glue up. Then when the the shorter segments of the cubes and triangles are glued into strips.

Thanks for the compliment,
Shane