Author Topic: 1  (Read 1733 times)

0 Members and 1 Guest are viewing this topic.

Offline roblg3

  • Posts: 751
  • Transforming into a whole new machine
1
« on: October 04, 2014, 12:57 AM »
\
« Last Edit: October 04, 2014, 07:17 AM by roblg3 »
Rob Gardner
Operator
RL3 Enterprises

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline alkaline

  • Posts: 410
Re: a lil help??
« Reply #1 on: October 04, 2014, 03:07 AM »
It is only a rough calculation. You can surely do a joke.


 [wink]
I have several boxes Festool, one MTF, four guide rails and big taste to play. )))

Offline wow

  • Inactive Member
  • *
  • Posts: 3579
  • Official WalMart greeter to the FOG
Re: a lil help??
« Reply #2 on: October 04, 2014, 05:45 AM »
Those '45's' are CLEARLY not 45's, so your 90's are not 90's. You can even see it in the picture.

Check the angle setting on whatever tool (table saw? Track saw? ) you used to cut the 45 degree cuts with.
Trying to be one of the most helpful members on the FOG.

Offline Peter Parfitt

  • Magazine/Blog Author
  • *
  • Posts: 4195
    • New Brit Workshop on YouTube
Re: a lil help??
« Reply #3 on: October 04, 2014, 06:04 AM »
Hi Rob

From where I am sitting it looks as though the top and left hand pieces are slightly wider than the others - this could be an optical illusion of course. As for the 45 deg check - only you can do this.

Perhaps you could check both aspects and let us know.

Peter

Offline Bohdan

  • Posts: 934
Re: a lil help??
« Reply #4 on: October 04, 2014, 06:47 AM »
Did you cut the angles at 45?

If the legs are tapered then the required angle is slightly less than 45 depending on the amount of taper.