Author Topic: G'day from downunder  (Read 408 times)

0 Members and 1 Guest are viewing this topic.

Offline DukeNinja

  • Posts: 2
G'day from downunder
« on: September 19, 2020, 03:09 AM »
Hi all,

I'm new to this forum. Had a bit of a windfall. So I splurged on some tools. Heard that this forum is great for brainstorming and peer support, so here I am.

My current stable has a CTL midi, DF500, TS75 and on order is the RO 125.

I have the UJK parf guide v2 that I've used to make a top.

I went for the TS75 purely because there was literally no TS55 available for weeks. I'll be using it for a variety of purposes, but does anyone have substantial experience of using it with sheet goods?

Ta.

Online SRSemenza

  • Global Moderator
  • *
  • Posts: 9656
  • Finger Lakes Region, NY State , USA
Re: G'day from downunder
« Reply #1 on: September 22, 2020, 10:46 AM »
Hi,

  Welcome to the forum!  [smile]

     See how your cuts come out on sheet goods. You may want to get the fine blade for the TS75. It comes with a combination blade. Some have acceptable results with the combination blade and some don't. Depends on how good your finished cut needs to be.

Seth

Offline David

  • Posts: 515
  • Author/speaker/advisor to entrepreneurial experts.
    • A few pieces that I’ve built
Re: G'day from downunder
« Reply #2 on: September 22, 2020, 11:54 AM »
Welcome! I'd tell you what Festool kit I have, but it could be used against me in a divorce court proceeding. :)
Fifth book (less interesting than woodworking) at http://www.expertise.is