Author Topic: Need to install baby gate  (Read 2917 times)

0 Members and 1 Guest are viewing this topic.

Offline BostonMike

  • Posts: 29
Need to install baby gate
« on: April 07, 2015, 03:48 PM »
I need to put up a baby gate at the top of my stairs...the hinge side will be on the wall but not sure where or how to place the opposite side...thinking of removing the balluster and putting in a 2x4

Photo with the gate is at the bottom, I will be putting the same type of gate at top of stairs


Any thoughts or suggestions would be appreciated

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline SMJoinery

  • Posts: 530
Re: Need to install baby gate
« Reply #1 on: April 07, 2015, 04:01 PM »
Hi

I wouldn't remove the balustrade just apply 4 pieces of timber around it to form a square box. When you no longer need the gate you can remove the overclad.

Offline rst

  • Posts: 2685
Re: Need to install baby gate
« Reply #2 on: April 07, 2015, 06:25 PM »
When my granddaughter was born I installed two.  One at the bottom and one at the top of the stairs.  I used poplar 1" X 2" stock out build out the wall and at the post and then attached the hinging and latch on those.  She is six now and I removed the one at the bottom but they retained the top ones to contain their dogs while they are at work.  It will be much easier to do a little patching after they are no longer needed than to remove your existing wood work.

Offline Klamp

  • Posts: 17
Re: Need to install baby gate
« Reply #3 on: April 07, 2015, 06:54 PM »
You can use U-bolts to attach a board to the baluster or use T-nuts like I did.  It's pretty ugly but equally functional.