Author Topic: Built in microwave and frameless cabinet  (Read 5491 times)

0 Members and 1 Guest are viewing this topic.

Offline wooden

  • Posts: 319
Built in microwave and frameless cabinet
« on: January 11, 2012, 11:02 AM »
I'm at a loss for this.

Cabinet is an upper.  36 inches tall, 27 inches wide overall.  There are doors on the top part of the cabinet and the opening for the built-in micro is on the bottom of the cabinet.  I have enough room in depth an width but not enough height.

The trim kits for microwaves all specify 19+ inch height requirement.  I have only 18 inches from bottom of doors above the opening to the very bottom edge of the cabinet.  When I received the cabinet, there was a blank finished piece covering the opening.

Is it normal to have to custom cut that blank and use it for the trim?  Or is there trim kit specific for frameless that I'm unable to find yet?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.