Author Topic: Interlocking joinery marking tool  (Read 537 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckM

  • Posts: 1280
Interlocking joinery marking tool
« on: October 14, 2019, 07:12 PM »
https://youtu.be/Jxa0-f0fchU?t=29

Is there a more economical, similar marking tool than the T-Marking Vernier Caliper (http://tinyurl.com/y5shq9fy) that the woodworker is seen using to mark the joints in the video? 

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Rob-GB

  • Posts: 1100
Re: Interlocking joinery marking tool
« Reply #1 on: October 15, 2019, 09:20 AM »
just use a standard woodworking marking gauge or Veritas type with the cutting wheel on the end of the bar.

Offline Jiggy Joiner

  • Posts: 804
Re: Interlocking joinery marking tool
« Reply #2 on: October 15, 2019, 01:01 PM »
Hi Chuck, a regular marking gauge and reliable square should suffice. Also the Incra precision T rules are very good, also a bit pricey though. I bought a set last year, and I now wonder how I managed without them.