Author Topic: CompressX Clamps  (Read 5295 times)

0 Members and 1 Guest are viewing this topic.

Offline casper

  • Posts: 16
CompressX Clamps
« on: October 28, 2008, 06:43 PM »
Have a look at this new type of clamp. As the Aussie dollar is very low against the USD at the moment they may be a good buy.

I have no connection or affiliation with the company.
« Last Edit: October 28, 2008, 06:44 PM by casper »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline alanz

  • Posts: 128
Re: CompressX Clamps
« Reply #1 on: October 28, 2008, 07:09 PM »
This looks along the same lines, but here you supply the wood cross bars

WoodRiver Clamping System

Triton 2.25 router; CMT Industrio table; Jointech fence; SC planer; Dewalt miter; Delta 14" bandsaw; Festool TS55, MFT/3, CT22, ETS150/3, OF1400, PSB300EQ; Dewalt Scrollsaw; Nova DVR XP lathe, JJ-6CS jointer, Ryobi OSS; Grizzly 1023s cabinetsaw