Author Topic: Newbie question Kem Aqua  (Read 1921 times)

0 Members and 1 Guest are viewing this topic.

Offline linnlp12

  • Posts: 67
Newbie question Kem Aqua
« on: December 12, 2016, 03:51 PM »
I see a lot of posts about using Sherwin Williams Kem Aqua Plus.  I understand it is waterborne.  Can anyone educate me on why it is so popular and advantage?  I found an older post describing the products but am really interested in why it is mentioned so much.  Also;
I purchased an Accuspray 240 system with a 10 Pro 1 bottom cup gun  from homestead.  I thought the recommendation might be Fuji but was recommended Accuspray based on
my discussion. I can find very little discussion re 240 turbine.  Any insight into comparison with the Fuji turbine would be appreciated (not the gun, just the turbine). This is just for my curiousity since I already made the purchase. 

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline tjbnwi

  • Posts: 6212
  • Cedar Tucky Indiana
Re: Newbie question Kem Aqua
« Reply #1 on: December 12, 2016, 04:48 PM »
I prefer KA because of the chemical content, or lack there of. There a few jobs I work on where solvent finishes do not meet the VOC spec set forth for the job. Easy clean up also.

Used an Accuspray once, have no real experience with it. I don't like the Gracco due to the whine/pitch of the turbine.