Author Topic: I wish for an edgebander stuffed into a sys 5  (Read 3245 times)

0 Members and 1 Guest are viewing this topic.

Offline Jon Hilgenberg

  • Posts: 1113
I wish for an edgebander stuffed into a sys 5
« on: October 06, 2012, 09:37 PM »
I've been doing a lot of on site repairs and modifications using iron on edge banding.  My buddy and I were joking that festool needs to come up with one that would fit in a sys 5.

So get to it. :)

The more Festools I buy, the more money I earn.  The more money I earn, the more Festools I buy.  The more...
TS 55, TS 75, Domino, CT22, OF 2000, C12, CXS, RAS, Trion, Fogtainers!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Oldwood

  • Posts: 480
  • Alberta, Canada
Re: I wish for an edgebander stuffed into a sys 5
« Reply #1 on: October 08, 2012, 02:16 PM »

I use this stuff for those odd repairs.
If they don't have a matching edge tape you can use the speed tape to make your own from PVC unglued edge tape.

Real knowledge is to know the extent of one's ignorance.

Offline Alan m

  • Posts: 3323
Re: I wish for an edgebander stuffed into a sys 5
« Reply #2 on: October 08, 2012, 03:19 PM »
that would be pritty cool. have a drawer on the front that pullls out to leave the slot for the pannel, the drawer would hold all the bits and bobs. have the top open to feed in glue and tape etc.
if the drawer was at a height of a sys1 plus maybe 1" for a special roller board that would clip onto a sys1  to act as an infeed and out feeed
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)