Author Topic: Height limit stop on my OF 1400  (Read 1681 times)

0 Members and 1 Guest are viewing this topic.

Offline Gary N.

  • Posts: 35
Height limit stop on my OF 1400
« on: December 20, 2012, 11:57 PM »
I am doing my first job with my LR 32 setup and my OF 1400 router. 8 ft. High closet panels. If I could limit the recoil to about 1/4" above the panel it would save about half my vertical movement and I wouldn't have to watch so close to keep from moving before the bit is out. I will have something invented for mine before this job is over. Soon I plan to have an air cylinder to push the router down with no effort. With it I'll have a green led the only lights when the router is in the up position and then I will only move to the next hole when the green light is on.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.