Author Topic: Drill adapter BA-CE (496450) with 1/4” std detent  (Read 1333 times)

0 Members and 1 Guest are viewing this topic.

Offline Ed Balaschak

  • Posts: 20
Drill adapter BA-CE (496450) with 1/4” std detent
« on: February 25, 2020, 01:26 AM »
I would like an adapter to allow the use of the centrotec chuck on my non festool drills/drivers. Please consider making an adaptation of the 496450 adapter where the 10mm? Hex is replaced by a 1/4” ball detent type geometry. I use the wera 7148c but would prefer to use the Centrotec chuck.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline FestitaMakool

  • Posts: 1010
Re: Drill adapter BA-CE (496450) with 1/4” std detent
« Reply #1 on: February 25, 2020, 03:36 PM »
Good call.
I second that!
“The Stig” Yes, it is true, at least some part of it..
“If you have an old Land Rover and a fit wife, you’re most likely always busy”