Author Topic: Bracket to connect my Kapex to my MFT  (Read 5192 times)

0 Members and 1 Guest are viewing this topic.

Offline paddler3d

  • Posts: 1
Bracket to connect my Kapex to my MFT
« on: August 13, 2013, 05:42 PM »
I work in old homes and space is a premium. Numerous times I've set up my Kapex on its cart with either the left or right extension and my MFT on the other side as the out feed support/worktable. I think when running base, I have it on the right so i can make my cut side my piece to the right, grab my Trion with a Collins coping foot and cope that miter. When I'm running crown, I've set it up on the left, make the cut, slide it into my gizmo to hold it at the right spring angle, grab my Trion and cope he miter.

The Kapex on the cart is the same height as the MFT and it would be nice to just lock those two together. Also that would allow you to clamp down your crown stop to the MFT.

Later!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 9659
  • Finger Lakes Region, NY State , USA
Re: Bracket to connect my Kapex to my MFT
« Reply #1 on: August 13, 2013, 06:03 PM »
Hi,

Welcome to the FOG!  [smile]


Granted it would be nice if that was available from Festool, but until then how about making one?  I am sure the UG Extensions brackets are available as parts. Two of those with a piece of wood in between. Make it what ever length you want.

Seth