Author Topic: 1/4" hex quick-change chuck  (Read 2382 times)

0 Members and 1 Guest are viewing this topic.

Offline veramis

  • Posts: 11
1/4" hex quick-change chuck
« on: October 11, 2011, 12:46 PM »
I just got a new t12 drill recently and I like it very much. I only wish it could lock onto 1/4" hex shanks just like how the centrotec chuck locks onto centrotec shanks. This would take away sales from centrotec bits but it would be a lot more convenient for customers.

Btw, does the cxs hold onto hex drill bits more securely when inserted directly than the t12?

Or in your next drill, incorporate 1/4" hex locking into the drill.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline VictorL

  • Posts: 582
Re: 1/4" hex quick-change chuck
« Reply #1 on: October 11, 2011, 01:08 PM »
This topic was discussed here several times in the past. Unlike centrotec bits, 1/4 bits are not precise. There are no any standards for them.
Every Festool drill goes with 1/4 magnetic bit holder, so you can use it.

VictorL