Author Topic: Kapex hold down  (Read 1575 times)

0 Members and 1 Guest are viewing this topic.

Offline bkharman

  • Posts: 2074
Kapex hold down
« on: October 01, 2015, 09:49 AM »
Hey everyone.  I was doing a lot of cuts on my Hitachi SCMS (CR12) and really like the saw but am allergic to the hold down.  It does work, but screwing and unscrewing constantly gets old.  I was wondering if someone could give the the pin diameter to see if it would work with my hold down holes.

Cheers.  Bryan.
People, I just want to say, you know, can we all get along? Can we get along?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline TylerC

  • Posts: 1084
Re: Kapex hold down
« Reply #1 on: October 01, 2015, 10:03 AM »
Sure. 21/32” is the small diameter. 23/32” is the large diameter.

Is that what you're looking for?
This account is retired. Please address all Festool questions to @festool usa.

Offline Sometimewoodworker

  • Posts: 777
    • Jerome's  Other work
Re: Kapex hold down
« Reply #2 on: October 01, 2015, 04:14 PM »
Hey everyone.  I was doing a lot of cuts on my Hitachi SCMS (CR12) and really like the saw but am allergic to the hold down.  It does work, but screwing and unscrewing constantly gets old.  I was wondering if someone could give the the pin diameter to see if it would work with my hold down holes.

Cheers.  Bryan.
You have the diameter above. I have modified one to sort of work with my Makita, it involved a lot of hand sanding with wet and dry.
Jerome
TS55, OF1400, Elu MOF96, Rotex150, DTS400, ETS150/3 Domino, MFK700, CXS, HL 850, Trend T11, Makita LS1212, Original Mini CV06 Cyclone, Workshop supplies drum sander, & WoodRat. Don't have don't want list: MFT
http://www.flickr.com/photos/nui-jerome/