Author Topic: TSC55 splinter guard help  (Read 224 times)

0 Members and 1 Guest are viewing this topic.

Offline Jonny14

  • Posts: 8
TSC55 splinter guard help
« on: September 13, 2020, 03:19 PM »
Hoping someone can help.

I took the cover off my tsc55 to clean it out and and a little metal clip has appeared from somewhere, which I can only presume is somehow related to keeping the splinter guard in place, as now it just falls out when I put it into the saw.

Does anyone know where this metal clip goes or how the splinter guard stays in place?
Any pictures available that I can look at?

Thanks guys

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Frank-Jan

  • Posts: 1092
  • Dutch Canadian living in Belgium
Re: TSC55 splinter guard help
« Reply #1 on: September 13, 2020, 07:47 PM »
Check out This thread
« Last Edit: September 13, 2020, 07:53 PM by Frank-Jan »

Offline Jonny14

  • Posts: 8
Re: TSC55 splinter guard help
« Reply #2 on: September 14, 2020, 05:29 PM »
Many thanks