Author Topic: TSC 55 REB disassemble  (Read 945 times)

0 Members and 1 Guest are viewing this topic.

Offline Stege

  • Posts: 4
TSC 55 REB disassemble
« on: January 14, 2022, 02:43 PM »
I will change the 10017862   Protective cover but I can't get the bolt out.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Svar

  • Posts: 2497
Re: TSC 55 REB disassemble
« Reply #1 on: January 14, 2022, 03:11 PM »
It is pressed fit and can be pushed/hammered out towards the handle/motor side.
What model is it? Looks like the handle is not blocking the pin and you don't have to remove motor housing.

Offline Stege

  • Posts: 4
Re: TSC 55 REB disassemble
« Reply #2 on: January 14, 2022, 03:37 PM »
thanks, it is a TSC 55 REB

Offline Svar

  • Posts: 2497
Re: TSC 55 REB disassemble
« Reply #3 on: January 14, 2022, 03:53 PM »
Good luck. Seems like they made an improvement. Press fit was on all previous models. I assume this one too. Handle side of the pin has tiny teeth/knurling around perimeter visible as is. Those chew into the aluminum housing securing it in place.

Offline Stege

  • Posts: 4
Re: TSC 55 REB disassemble
« Reply #4 on: January 14, 2022, 04:10 PM »
That may well be the case. It has to hold up in the new part.

Offline Stege

  • Posts: 4
Re: TSC 55 REB disassemble
« Reply #5 on: January 15, 2022, 06:06 PM »
That may well be the case. It has to hold up in the new part.
Yes your answer was correct.
Big Thanks

Offline Svar

  • Posts: 2497
Re: TSC 55 REB disassemble
« Reply #6 on: January 15, 2022, 07:14 PM »
I found that on all TS saw I tried there is a little play between the pin and plunge part of the saw. Such that it can wobble laterally 0.1 mm or so, the pin is also slightly undersized. What I like on Mafell is that it's bronze bearings with perfect fit.