Festool Owners Group

FESTOOL DISCUSSIONS => Festool Tools & Accessories => Topic started by: Stege on January 14, 2022, 02:43 PM

Title: TSC 55 REB disassemble
Post by: Stege on January 14, 2022, 02:43 PM

I will change the 10017862   Protective cover but I can't get the bolt out.

Title: Re: TSC 55 REB disassemble
Post by: Svar on January 14, 2022, 03:11 PM

It is pressed fit and can be pushed/hammered out towards the handle/motor side.
What model is it? Looks like the handle is not blocking the pin and you don't have to remove motor housing.

Title: Re: TSC 55 REB disassemble
Post by: Stege on January 14, 2022, 03:37 PM

thanks, it is a TSC 55 REB

Title: Re: TSC 55 REB disassemble
Post by: Svar on January 14, 2022, 03:53 PM

Good luck. Seems like they made an improvement. Press fit was on all previous models. I assume this one too. Handle side of the pin has tiny teeth/knurling around perimeter visible as is. Those chew into the aluminum housing securing it in place.

Title: Re: TSC 55 REB disassemble
Post by: Stege on January 14, 2022, 04:10 PM

That may well be the case. It has to hold up in the new part.

Title: Re: TSC 55 REB disassemble
Post by: Stege on January 15, 2022, 06:06 PM

Quote from: Stege on January 14, 2022, 04:10 PM

That may well be the case. It has to hold up in the new part.

Yes your answer was correct.
Big Thanks

Title: Re: TSC 55 REB disassemble
Post by: Svar on January 15, 2022, 07:14 PM

I found that on all TS saw I tried there is a little play between the pin and plunge part of the saw. Such that it can wobble laterally 0.1 mm or so, the pin is also slightly undersized. What I like on Mafell is that it's bronze bearings with perfect fit.