Author Topic: TS55 base plate holes?  (Read 554 times)

0 Members and 1 Guest are viewing this topic.

Offline kazas

  • Posts: 7
TS55 base plate holes?
« on: July 27, 2022, 02:41 PM »
Hello Everyone,

The base plate (or shoes base) of a TS 55 has two holes (see attachment). Does anyone knows what are they used for?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Coen

  • Posts: 1967
Re: TS55 base plate holes?
« Reply #1 on: July 27, 2022, 03:06 PM »
The hex holes hold a nut that is then used to clamp the parallel guide with a threaded knob from the other side. Said nuts are provided with the parallel guide (#491469)


If you look careful in the bottom right you can just see a part of said nuts.
« Last Edit: July 27, 2022, 04:02 PM by Coen »

Offline gwendal

  • Posts: 35
Re: TS55 base plate holes?
« Reply #2 on: July 27, 2022, 03:51 PM »
or 3d printed anti tilt stops

Offline kazas

  • Posts: 7
Re: TS55 base plate holes?
« Reply #3 on: July 27, 2022, 04:50 PM »
Thank you both. You were really helpful.