Author Topic: TS 55 REQ PLUS adjustment  (Read 261 times)

0 Members and 1 Guest are viewing this topic.

Offline seturner

  • Posts: 9
TS 55 REQ PLUS adjustment
« on: April 27, 2021, 06:27 PM »
Hello,

I have read through posts addressing the issue of saw not cutting perpendicular to surface, but none I have read addressed the newer ts 55 with the two rear adjustment screws.  I know where they are, but do not know how to utilize them properly.

My relatively new saw is not cutting properly(gap in top when cutting workpiece and flipping Offcuts side over).

Can anybody assist?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Frank-Jan

  • Posts: 1184
  • Dutch Canadian living in Belgium