Author Topic: TS 55 kerf/rail offset  (Read 2221 times)

0 Members and 1 Guest are viewing this topic.

Offline nikev

  • Posts: 41
TS 55 kerf/rail offset
« on: April 23, 2007, 04:32 PM »

I am wondering whether there is any data available the about the specified offset between the back (the aluminium part furthest from the saw blade; NOT the splinter guard side) of the saw guide rail and the edge of the kerf left by the blade. What is this offset supposed to be, assuming the saw is correctly adjusted and the cams on the guide are tight??



Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.