Author Topic: Sys Vac and veneer  (Read 287 times)

0 Members and 1 Guest are viewing this topic.

Offline UncleJoe

  • Posts: 149
Sys Vac and veneer
« on: November 27, 2020, 10:30 AM »
I did a search but I could not find a conclusive answer. Can the sys vac be used with veneer bags for veneering? I realize there can be a lot of variables such as work piece size etc. but I am interested in anyone's experience with this.
I am not young enough to know everything!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline afish

  • Posts: 446
Re: Sys Vac and veneer
« Reply #1 on: November 27, 2020, 02:21 PM »
I dont have the festool unit but the consensus is yes it can.  Vacuum is vacuum after all.  I havent seen anyone post #'s how much vacuum the festool unit can pull but some have claimed to have vacuum bagged with the unit.  The other down fall is the festool runs continuously.  Most vacuum pumps made for pressing will cycle on and off as needed to maintain consistent vacuum. You can also use any old air compressor to make a vacuum pump if you prefer.