Author Topic: Festool 482107 Guide Rail Connector, distance between the screws?  (Read 762 times)

0 Members and 1 Guest are viewing this topic.

Offline threesixright

  • Posts: 405
Hi,

Anybody that has these connectors, could measure the distance between the screws (center to center), as on the picture?

Total length would be also great.

Much obliged!

--
Roger

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline GarryMartin

  • Posts: 1817
Re: Festool 482107 Guide Rail Connector, distance between the screws?
« Reply #1 on: February 27, 2019, 06:49 AM »
Length between the centres you've marked in red is 80mm. Between the two centre fixings is 96mm. Overall length is 315mm.

Offline threesixright

  • Posts: 405
Re: Festool 482107 Guide Rail Connector, distance between the screws?
« Reply #2 on: February 27, 2019, 07:29 AM »
Length between the centres you've marked in red is 80mm. Between the two centre fixings is 96mm. Overall length is 315mm.

Sir, you're awesome. Thanks!

Offline ben_r_

  • Posts: 1232
Re: Festool 482107 Guide Rail Connector, distance between the screws?
« Reply #3 on: February 28, 2019, 05:29 PM »
Whatcha up to? Why were you lookin for that info?
If at first you don't succeed, redefine success!

Offline threesixright

  • Posts: 405
Re: Festool 482107 Guide Rail Connector, distance between the screws?
« Reply #4 on: March 01, 2019, 04:44 AM »
Whatcha up to? Why were you lookin for that info?

Hehe, first to ask [wink]. Curiosity killed the cat!  [tongue]

J/K as side.

Was looking to create a poor men's  square.  Basically taking the rail connectors (#482107) and put a t-slot profile (400mm) perpendicular to the rail . Now the slots needs to be, according to the measurements 80mm apart. Basically needed the info to check if I could find a t-slot rail where the slots are 80 mm apart.