Author Topic: MFS Router Insert  (Read 3360 times)

0 Members and 1 Guest are viewing this topic.

Offline Doug Anders

  • Posts: 29
MFS Router Insert
« on: February 05, 2007, 07:05 PM »
Do you reckon Festool USA will offer this router table insert for the MFS system?


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline MarkusS

  • Posts: 59
Re: MFS Router Insert
« Reply #1 on: February 06, 2007, 06:20 PM »
I'm sure that this is not a Festool part - I've never seen this before and this doesn't look like Festool, this is a raw aluminium sheet, no finish on the surface, nothing.

Should be quite easy to do something like this "yourself" - a sheet of aluminium and a few drills.

Regards
Markus

Offline Doug Anders

  • Posts: 29
Re: MFS Router Insert
« Reply #2 on: February 06, 2007, 07:02 PM »
You're right, Markus. I got the image from the Geat website that you pointed out on another thread. I'm going to try to make a couple out of some clear acrylic I have laying around.

Offline Christian Oltzscher

  • Festool Employee.
  • Posts: 157
Re: MFS Router Insert
« Reply #3 on: February 07, 2007, 04:30 PM »
Doug,

Festool will not offer this router table insert for the MFS in the US. UL would get a heart attack
if we submitted this insert  :D

Regards,

Christian

Offline Ned

  • Posts: 1146
Re: MFS Router Insert
« Reply #4 on: February 07, 2007, 04:53 PM »
UL would get a heart attack
if we submitted this insert  :D

I get a heart attack looking at that picture.  ;D

Ned

Offline Jim Becker

  • Posts: 169
  • Think twice...write once...
    • Saws 'N Dust
Re: MFS Router Insert
« Reply #5 on: February 12, 2007, 04:05 PM »

I get a heart attack looking at that picture. 




Me too...'dem fingers are way too close to the cutter and I don't see any starting pin in use. (It could be there, but I can't see it...)
“Never raise your hands to your children, it leaves your groin unprotected.” - Red Buttons