Festool Owners Group

FESTOOL DISCUSSIONS => Festool Tools & Accessories => Topic started by: Doug Anders on February 05, 2007, 07:05 PM

Title: MFS Router Insert
Post by: Doug Anders on February 05, 2007, 07:05 PM
Do you reckon Festool USA will offer this router table insert for the MFS system?

(http://www.surfingmussel.com/Router Insert.jpg)
Title: Re: MFS Router Insert
Post by: MarkusS on February 06, 2007, 06:20 PM
I'm sure that this is not a Festool part - I've never seen this before and this doesn't look like Festool, this is a raw aluminium sheet, no finish on the surface, nothing.

Should be quite easy to do something like this "yourself" - a sheet of aluminium and a few drills.

Regards
Markus
Title: Re: MFS Router Insert
Post by: Doug Anders on February 06, 2007, 07:02 PM
You're right, Markus. I got the image from the Geat website that you pointed out on another thread. I'm going to try to make a couple out of some clear acrylic I have laying around.
Title: Re: MFS Router Insert
Post by: Christian Oltzscher on February 07, 2007, 04:30 PM
Doug,

Festool will not offer this router table insert for the MFS in the US. UL would get a heart attack
if we submitted this insert  :D

Regards,

Christian
Title: Re: MFS Router Insert
Post by: Ned on February 07, 2007, 04:53 PM
UL would get a heart attack
if we submitted this insert  :D

I get a heart attack looking at that picture.  ;D

Ned
Title: Re: MFS Router Insert
Post by: Jim Becker on February 12, 2007, 04:05 PM

I get a heart attack looking at that picture. 




Me too...'dem fingers are way too close to the cutter and I don't see any starting pin in use. (It could be there, but I can't see it...)