Author Topic: Kapex question  (Read 472 times)

0 Members and 1 Guest are viewing this topic.

Offline Sci

  • Posts: 26
Kapex question
« on: May 11, 2021, 06:49 PM »
I am a cabinet maker and trim guy.  I do more cabinets than trim jobs.  Currently I use a DeWalt sliding miter and a Bosch axial glider. 

I make a lot of shelves.  Usually around 12 to 13" deep.  Both the DeWalt and Bosch will cut these depth shelves in a single pass. 

How deep of a shelf (3/4") plywood will a Kapex cut in a single pass?

Thanks

Mark

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline DynaGlide

  • Posts: 1096
Re: Kapex question
« Reply #1 on: May 11, 2021, 07:00 PM »
12 inches
Instagram @matts.garage

Offline Sci

  • Posts: 26
Re: Kapex question
« Reply #2 on: May 12, 2021, 03:54 PM »
Thanks