« previous next »
Pages: [1]   Go Down

Author Topic: fs-wa/90  (Read 1181 times)

0 Members and 1 Guest are viewing this topic.

Offline 3D Prints and More

  • Retailer
  • *
  • Posts: 6
fs-wa/90
« on: June 22, 2022, 08:28 AM »
Hello to all
could anybody give me the dimension between the 2 threaded holes on the fs-wa/90 angle stop. i am trying to sort a bigger more stable anti tilt clip.
Thank you kindly
Sean
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline NiteWalkerGR

  • Posts: 192
Re: fs-wa/90
« Reply #1 on: June 22, 2022, 11:47 AM »
60mm between the two holes by the nib that slides in the rail, 100mm between the two where the label plate is.
Logged

Offline Coen

  • Posts: 2353
Re: fs-wa/90
« Reply #2 on: June 22, 2022, 02:38 PM »
A piece of lead underneath the other end  [tongue]?
Logged

Offline 3D Prints and More

  • Retailer
  • *
  • Posts: 6
Re: fs-wa/90
« Reply #3 on: June 23, 2022, 05:49 AM »
Hi
thank you for the reply
yes the label plate fantastic.
Coen lol not a piece of lead no.
Sean
Logged

Offline 3D Prints and More

  • Retailer
  • *
  • Posts: 6
Re: fs-wa/90
« Reply #4 on: July 04, 2022, 08:31 AM »
Hello, just a quickie....i have changed my design.
would anybody like to trial it and give me some feedback?
free of charge i will send it to you as long as the postage is not extortionate....
let me know.

Thank you
« Last Edit: July 04, 2022, 11:24 AM by 3D Prints and More »
Logged

Offline 3D Prints and More

  • Retailer
  • *
  • Posts: 6
Re: fs-wa/90
« Reply #5 on: July 04, 2022, 11:25 AM »
Sorry forgot to attach the image
Logged
Pages: [1]   Go Up
« previous next »