Author Topic: Festool Bit Holder Reference Topic  (Read 5247 times)

0 Members and 1 Guest are viewing this topic.

Online six-point socket II

  • Posts: 1054
  • aka @the_black_tie_diyer
Re: Festool Bit Holder Reference Topic
« Reply #30 on: November 05, 2019, 06:25 AM »
Oliver,

    Does the Centrotec Rapidapter stay in the unlocked / forward position?  Or do you have to hold it forward to insert / remove bits?

Seth

Hi Seth,

I'm sorry, I have only seen your question now.

Pretty sure it does. I will check later and get back to you!

Kind regards,
Oliver

As expected, it does. :) (Sorry, just noticed it was already clear with @Dick Mahany 's post , I'm a little sidelined right now.)





Kind regards,
Oliver
Kind regards,
Oliver

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.