Author Topic: CT26E + Boom Arm: Cord Management  (Read 205 times)

0 Members and 1 Guest are viewing this topic.

Offline gte619n

  • Posts: 1
CT26E + Boom Arm: Cord Management
« on: May 22, 2020, 11:32 AM »
Gentlemen, I just installed the 203151 CT Boom Arm Set on my CT26E. Overall I like it, but I'm a little confused as to what to do about the vacuum cord. The kit came with a replacement for the cord wrap that supports the vertical arms. That's fine, but how/where am I supposed to wrap the cord? Am I missing something?

Thank you!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Dove_Tail

  • Posts: 41
Re: CT26E + Boom Arm: Cord Management
« Reply #1 on: May 22, 2020, 12:08 PM »
I use the rear tool hook for my cord as I normally only use the front hook for hanging a sander.