Author Topic: converting to multi-jetstream 2  (Read 295 times)

0 Members and 1 Guest are viewing this topic.

Offline demps

  • Posts: 1
converting to multi-jetstream 2
« on: September 09, 2020, 08:00 AM »
I have RO 150 and ETS 150 sanders, both 10 years old or so.  Original 9 hole paper.  Can I convert to multi-jetstream 2 by simply buying paper and new sanding pads?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Peter Halle

  • Global Moderator
  • *
  • Posts: 12367
  • Remington Steele - My Third Boy
Re: converting to multi-jetstream 2
« Reply #1 on: September 09, 2020, 08:50 AM »
Welcome to the forum.  That is what I did.  But do note that the old paper will line up with the new pattern so that it is at least usable.  Just won't have as many holes as the new pattern.

Hope this makes sense.


Offline Alex

  • Posts: 7349
Re: converting to multi-jetstream 2
« Reply #2 on: September 09, 2020, 09:27 AM »
It is all backwards compatible. Note that the newer paper has little to no noticeable improvement, so don't throw your old stuff away but use it until you're out.