Author Topic: Connecting the Kapex MFT to the MFT 3 table  (Read 687 times)

0 Members and 1 Guest are viewing this topic.

Offline mnwitt

  • Posts: 3
Connecting the Kapex MFT to the MFT 3 table
« on: October 23, 2020, 08:43 PM »
Has anyone connected the Kapex MTF to an MFT 3? As far as I can tell there are no Festool products to accomplish this. I am using the Kapex on a Kapex table between two MFT 3s. I want to be able to clamp stops on to the adjacent MFT 3s to make accurate repetitive cuts. I can probably create a fixture to connect tables together but was curious what other owners have done. Thanks in advance.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline johnsayen

  • Posts: 43
Re: Connecting the Kapex MFT to the MFT 3 table
« Reply #1 on: October 24, 2020, 07:50 PM »
Take a look in the supplemental manual here, they show you a couple options with festool products. One is clamps, the other a screw/nut combo.

Offline jobsworth

  • Posts: 6741
  • Festool Baby.....
Re: Connecting the Kapex MFT to the MFT 3 table
« Reply #2 on: October 24, 2020, 09:26 PM »

easy when you set the MFT3 next to the Kapex MFT use the fence from the MFT3 along with the compass assy and the flag stops that come with the MFT3 buy more flag stops if necessary. you dont need the MFT3 fence to be prefect aligned with the Kapex. If you need longer fence make one and make a stop for it.

Offline Ajax

  • Posts: 199
Re: Connecting the Kapex MFT to the MFT 3 table
« Reply #3 on: February 27, 2021, 10:44 PM »
Is there a way to connect the Kapex MFT to the MFT 3?

There are connectors for connecting 2x MFT 3's together.
Kapex KS120, 2 x MFT/3, TS55 REQ, TS75, LS130, RTS400, RO90 DX FEQ, D90 Assortment, RO150 REQ, ETS 150/3, PRO5, D150 Assortment, DF 500, Domino 4/5/8/10 Assortment, DF700 XL, Domino 12/14 Assortment,  CT Midi, MFT/3, Kapex MFT, 2 x SysRoll