Author Topic: Boom arm and workcentre - anyone use it?  (Read 457 times)

0 Members and 1 Guest are viewing this topic.

Offline kifi

  • Posts: 28
Boom arm and workcentre - anyone use it?
« on: August 05, 2022, 04:02 PM »
Hi all

Striving for more efficiency I am looking to see if a boom arm and workcenter might speed up my track sawing, and sanding m.

I don’t see too much feedback here, or maybe I haven’t been tuned into it on the past.

Anyone use the boom arm and workcentre /CT36 etc?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Jeff Zanin

  • Posts: 309
Re: Boom arm and workcentre - anyone use it?
« Reply #1 on: August 06, 2022, 06:37 AM »
I have both mounted on a CT36.  It is fine for what I am doing, but not particularly portable.

Offline festal

  • Posts: 393
Re: Boom arm and workcentre - anyone use it?
« Reply #2 on: August 06, 2022, 08:02 AM »
Like Jeff said, it works but takes up alot of room.  Its huge.  lol I have it hooked up to ct-48
I might end up selling the boom arm and keep the work center.  Still testing
also note that 3.5m hose is too short for boom arm.  5m would work much better