Author Topic: Adjusting angle of saw blade  (Read 257 times)

0 Members and 1 Guest are viewing this topic.

Offline Stenis49

  • Posts: 4
Adjusting angle of saw blade
« on: December 12, 2020, 12:02 PM »
My CS 70 is not perfect square between saw blade and table. Is there any possibility to fix that?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Alex

  • Posts: 7351
Re: Adjusting angle of saw blade
« Reply #1 on: December 12, 2020, 12:58 PM »
I had this once until I noticed a piece of wood was obstructing free movement. Try to see if you can find any obstructions.

I'm sure you can adjust the angle somewhere, but I never needed it so I have not looked into it. I guess it does need opening the under carriage.

Also make sure the carriage runs even on both sides on the metal rods.