« previous next »
Pages: [1]   Go Down

Author Topic: 6'' driver bit R2 for DWC 18-4500  (Read 252 times)

0 Members and 1 Guest are viewing this topic.

Offline Gabeo

  • Posts: 1
6'' driver bit R2 for DWC 18-4500
« on: November 03, 2019, 02:49 PM »
HI there, new on the page.
I used to have a Senco gypsum drill and used both phillips head and R2 for decking etc.... using galvanized screws for makita etc....

Since I have plenty of flooring and decking screws in stock, i was looking for 6'' driver bit in sqare R2 but those I can find (in montreal area) are round but thicker, and i need to fine a thinner core to fit into the automatic attachement.

Any ideas or link?
Thanks
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Pages: [1]   Go Up
« previous next »