Author Topic: 27mm to 2-1/4" ID Adapter  (Read 264 times)

0 Members and 1 Guest are viewing this topic.

Offline Eko

  • Posts: 26
27mm to 2-1/4" ID Adapter
« on: September 14, 2023, 12:26 PM »
I've been looking for a dust port adapter to connect my Festool 27mm hose to a 2-1/2" OD / 2-1/4" ID dust port on a benchtop planer. I've purchased (and returned) a few 3D printed adapters because they were a hair too small on the 2-1/4" end though they fit the Festool hose perfectly. I'd really like to avoid the purchase/return - trial and error approach if possible.

Any recommendations?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Packard

  • Posts: 2731
Re: 27mm to 2-1/4" ID Adapter
« Reply #1 on: September 14, 2023, 12:58 PM »
There appears to be several options, including a few from  Both swivel and non-swivel choices.