Author Topic: OF1400  (Read 5059 times)

0 Members and 1 Guest are viewing this topic.

Offline zapdafish

  • Posts: 540
OF1400
« on: September 21, 2011, 09:12 PM »
I got it yesterday. Hooked it up to my CT22 today and used a flush trim bit to edge mdf on my torsion box build. All I can say is WOW. Last time I used a router on MDF I was covered in dust. I didn't see dust anywhere.

I was kinda going back and forth in my mind bewteen  a PC, Dewalt and OF1400 because of the price but then I remembered I had already invested in dust collection and after that it was a no brainer.

CT22, TS55, Kapex, RO150, Domino, RS 2 E

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 8998
  • Finger Lakes Region, NY State , USA
Re: OF1400
« Reply #1 on: September 22, 2011, 12:07 AM »
Yup the 1400 leaves the competion in the dust  [big grin]

It is so easy to control  and so smooth compared to any other that I have used.


Seth

Offline morts10n

  • Posts: 221
Re: OF1400
« Reply #2 on: September 23, 2011, 07:37 PM »
I was a bit disappointed that I could not use the dust collection hood that goes under the base, when routing an inside corner. Seems like a lot of dust is created right there around the bit, but it gets in the way when turning an inside corner.

Offline Alan m

  • Posts: 3312
Re: OF1400
« Reply #3 on: September 24, 2011, 05:59 PM »
pity festool doesnt have one with two sprug loaded halfs that slide past each other to allow it to get smaller in the corner
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)