Author Topic: ETSC Dust Collection  (Read 1056 times)

0 Members and 1 Guest are viewing this topic.

Offline CarlsonCarpentry

  • Posts: 125
ETSC Dust Collection
« on: July 08, 2020, 01:02 AM »
Recently picked up the ETSC to fill that void in my Sys combi, next to my RTSC. Here is a quick video I took (I’m not a talented videographer).

I’m sanding primed mdf overhead. You can see how much the sander is pulling in.

I’ll do a light vacuuming after the shelving is installed in the closet but that’s it.

« Last Edit: July 08, 2020, 01:14 AM by CarlsonCarpentry »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Euclid

  • Posts: 243
Re: ETSC Dust Collection
« Reply #1 on: July 11, 2020, 05:10 AM »
That's a useful bit of filming, thank you.
It's interesting to see - even without being attached to a powered DC - how it pulls back some of the dust escaping from the edge of the pad.

I've been wavering on buying that particular sander, but this - and with the imminent arrival if the edge sanding attachment (which, if I read the announcements correctly, will fit this sander too) I'm now convinced...
« Last Edit: July 11, 2020, 05:13 AM by Euclid »