Author Topic: WedgeDog Vise Now Available  (Read 570 times)

0 Members and 1 Guest are viewing this topic.

Offline Bob D.

  • Retailer
  • *
  • Posts: 3038
    • My Cordless Workshop
WedgeDog Vise Now Available
« on: September 18, 2022, 08:21 PM »
The Cordless Workshop WedgeDog Vise is now available to order.

This wedge vise is made to use with the MFT/3 and works with just about any worktop with 20mm dog holes spaced in a 96x96mm grid such as the Stanton Bench or a Paulk Bench or a custom worktop you create using the Parf System.

It can be secured to the bench using a Festool 8mm knob or you can get our Modular Knob Kit which can be used with M8 or 5/16" hardware.

http://www.cordlessworkshop.net/wedge-dog-vise.shtml


« Last Edit: September 18, 2022, 08:25 PM by Bob D. »
-----
It's a table saw, do you know where your fingers are?

Offline Bob D.

  • Retailer
  • *
  • Posts: 3038
    • My Cordless Workshop
Re: WedgeDog Vise Now Available
« Reply #1 on: September 30, 2022, 12:09 PM »
I have my Modular Knob Kit available on the website. With it you can make either a 5/16" or M8 knob using whatever length bolt you need or insert a hex nut and use the knob with a 5/16" or M8 stud.

The kit comes with two M8-1.25 x 16mm HH bolts so you can put the knobs right to work with your MFT, Stanton Bench, or other worktop.

$14 for a set of two knobs. More info on the website.

http://cordlessworkshop.net/wedge-dog-vise.shtml

-----
It's a table saw, do you know where your fingers are?