Author Topic: New Zero Clearance Fence for Kapex (The Cube)  (Read 10081 times)

0 Members and 1 Guest are viewing this topic.

Offline Frank-Jan

  • Posts: 1122
  • Dutch Canadian living in Belgium
Re: New Zero Clearance Fence for Kapex (The Cube)
« Reply #60 on: January 13, 2021, 05:32 PM »
When installing the fence, is there calibration required? (Just drawing a line before unscrewing the original fence, or clamping a straightedge to the table, or does it register in some way that it can't go wrong).

I'm asking this because my fence has arrived at customs, and I don't know how long that will take, but my saw is also an older model, that's affected by the callback and has to be sent in for repair somewhere in february, and I'm going to return it to stock before sending it in.

Offline Colliflower

  • Retailer
  • *
  • Posts: 52
Re: New Zero Clearance Fence for Kapex (The Cube)
« Reply #61 on: January 14, 2021, 11:09 AM »
When installing the fence, is there calibration required? (Just drawing a line before unscrewing the original fence, or clamping a straightedge to the table, or does it register in some way that it can't go wrong).

I'm asking this because my fence has arrived at customs, and I don't know how long that will take, but my saw is also an older model, that's affected by the callback and has to be sent in for repair somewhere in february, and I'm going to return it to stock before sending it in.

Hello, Frank-Jan.
Yes, I think it's best to make sure the fence is nice and square with the blade, so there will likely be a bit of adjustment. And yes, it would be a good idea to draw a line so that when your Kapex comes back, you can put the Cube right back in place. That would make it easiest. Glad to hear it's almost to you!