Author Topic: Free Tools (again )  (Read 3242 times)

0 Members and 1 Guest are viewing this topic.

Offline Dogberryjr

  • Posts: 143
Re: Free Tools (again )
« Reply #30 on: October 29, 2019, 03:46 PM »
They look handy.  What is the overall height when fully closed?  I'm hoping they may work with the orange LV saddle clamp set up as that would allow for clamping in tight spaces.

Three inches, fully closed. Maximum throat fully opened: ~1 5/16"  And yes, an accompanying note specifies that they were designed to work with the Veritas Panel Platform Kit.

Offline Michael Kellough

  • Posts: 4314
Re: Free Tools (again )
« Reply #31 on: October 29, 2019, 05:06 PM »
(Attachment Link)
what was the prize at the end?
Funny you should ask. A pair of these was just delivered. I think they'll come in handy. "Low Profile Track Clamp."

They look handy.  What is the overall height when fully closed?  I'm hoping they may work with the orange LV saddle clamp set up as that would allow for clamping in tight spaces.

Might be why they made them.

Offline Dick Mahany

  • Posts: 547
Re: Free Tools (again )
« Reply #32 on: October 29, 2019, 05:25 PM »
They look handy.  What is the overall height when fully closed?  I'm hoping they may work with the orange LV saddle clamp set up as that would allow for clamping in tight spaces.

Three inches, fully closed. Maximum throat fully opened: ~1 5/16"  And yes, an accompanying note specifies that they were designed to work with the Veritas Panel Platform Kit.

@Dogberryjr , thank you for the info.  Now I just need to see them get added to the LV catalog  [smile]

Offline Bob D.

  • Posts: 1390
Re: Free Tools (again )
« Reply #33 on: October 29, 2019, 08:28 PM »
Mine showed up today too, totally unexpected. I had forgotten about this until I saw a box on the porch and then saw it was from  LV. Even then I thought to myself that I had not ordered anything lately what could it be. Then I read Rob's note and it came back.

The clamps look great and a nice compact size. They fit easily in the Systainer with my TSC55 and that is where they will be from now on so that I won't be searching for them when needed.

I checked and they fit my DeWalt TS rails too and they will probably fit many other brands.

Thank you Rob, much appreciated.
« Last Edit: October 30, 2019, 09:32 PM by Bob D. »
-----
It's a table saw, do you know where your fingers are?

Offline live4ever

  • Posts: 829
Re: Free Tools (again )
« Reply #34 on: November 04, 2019, 08:53 PM »
Mine arrived today!  These are going to be great with the panel platform kit, which I still haven't broken out of the box.  Hope to put both through their paces this upcoming weekend.  The rubber bumpers on the clamp arms are a thoughtful touch.

Thanks Rob! 
Current systainer to productivity ratio:  very high