Author Topic: Squaring MFT/3 (the 999th time)  (Read 3155 times)

0 Members and 1 Guest are viewing this topic.

Offline Slartibartfass

  • Posts: 1054
  • How'ur'duin'......
    • The Accidental NAINA Store Email List
Squaring MFT/3 (the 999th time)
« on: May 28, 2014, 05:30 PM »
I tried to make it as easy and simple with as little setup tools as necessary. Only 4 dogs required....

I realized when using the fence clamps that a slight mod would take care of the slight gap to the dogs without the need of a piece of wood as shown by others. Fence clamp top can now move back and forth.

I used a 1/4 drill for the top and 3/8 drill from the bottom to connect the 2 individual holes on the fence clamp milling the plastic away on my drill press.

107061-0

Top of fence clamp before and after milling:

107063-1

Bottom of fence clamp before and after milling:

107065-2

Fence squared:

107067-3

Rail squared (i just moved it back and away from the stops towards the dogs:

107069-4

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline stphnlwlsh

  • Posts: 62
Re: Squaring MFT/3 (the 999th time)
« Reply #1 on: May 30, 2014, 11:58 AM »
That looks like a good setup!