Author Topic: Shortcut to depth readings on TS75  (Read 1741 times)

0 Members and 1 Guest are viewing this topic.

Offline Joseph C

  • Posts: 266
    • Integrity Design+Build
Shortcut to depth readings on TS75
« on: May 14, 2014, 12:38 AM »
One of out members has rather ingeniously made imperial labels for the OF1400 and for the TS55.  Unfortunately, the TS75's geometry is a little different, so no such labels are available for us.
And even though I know where I like my settings for 1/2" and 3/4" materials, I still have to look for the mark every time.

I had a rare inspired moment the other day, and made a story pole for my typical cut depths by inking over their marks (21 mm, 27mm, & 45mm) with a red sharpie!
Now I have an easy visual reference for my typical depths of cut!    [big grin]

TS75, OF1010, PS300, Domino500, MFT/3, CT22 + WCR, CT MIDI, RS2e, RO150, ETS150, DS400, RO90, Grex 2" micropinner (festool green), and packing everything else into systainers, too.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.