Author Topic: New Cutting Table  (Read 4453 times)

0 Members and 1 Guest are viewing this topic.

Offline BobKovacs

  • Posts: 299
New Cutting Table
« on: September 18, 2010, 03:24 PM »
'm gearing up to start a big coffered ceiling/wainscot/built-ins project in my home office, so I needed to put together a cutting table to break down the sheet goods. While not as elaborate as the collapsing/sliding tables in other threads, it works well, and is a great height for a tall guy like me when sitting on the MFT table (puts it at about 40" high).

I had a 1/2 sheet of 3/4 birch ply hanging around, so I ripped it into 3 1/2" strips using the new Festool parallel guides (practice for the big project). It's fastened together with pocket screws, and measures 3'x6'. I'd say it weighs around 10 lbs, so it'll be easy to sling into the back of the truck if need be.

Sorry for the bad picture quality- I was too lazy to go find the camera, so I just snapped them with my Blackberry.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.