Author Topic: My hybrid version of a DIY MFT Sysport  (Read 15461 times)

0 Members and 1 Guest are viewing this topic.

Offline nicholam77

  • Posts: 82
Re: My hybrid version of a DIY MFT Sysport
« Reply #30 on: April 09, 2021, 11:02 AM »
Small addition - I made a docking station / storage solution for my Woodpecker MFT Square:





It's kind of large and before it didn't have a home. Now it's at the ready, on the MFT, stored vertically so it doesn't take up much space.
CT15 | ETS 125 REQ

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline John Huh

  • Posts: 39
    • Tidbits
Re: My hybrid version of a DIY MFT Sysport
« Reply #31 on: April 17, 2021, 12:37 AM »
Small addition - I made a docking station / storage solution for my Woodpecker MFT Square:





It's kind of large and before it didn't have a home. Now it's at the ready, on the MFT, stored vertically so it doesn't take up much space.

That's pretty slick!

Offline Wood_Slice

  • Posts: 102
Re: My hybrid version of a DIY MFT Sysport
« Reply #32 on: April 17, 2021, 07:05 PM »
@nicholam77
What size length drawer slides did you use in order to open the trays completely and open the lid fully?
DF 500 + Assortments | ETS EC 125/3 EQ | CT MIDI + CT-Fi| MFT3 + Elements| Installer's Set | TS55-REQ |

Offline nicholam77

  • Posts: 82
Re: My hybrid version of a DIY MFT Sysport
« Reply #33 on: April 17, 2021, 07:44 PM »
@nicholam77
What size length drawer slides did you use in order to open the trays completely and open the lid fully?
I used 14” full extension slides. My systainers sit back from the face of the drawer a bit because there is a 1/2” ply front, but in my situation 14” slides just barely cut it. 15” would be better. But you could get away with 14” especially if your trays don’t have front pulls.
CT15 | ETS 125 REQ