Author Topic: Lee Valley drill press table and MFT stops!  (Read 2019 times)

0 Members and 1 Guest are viewing this topic.

Offline gnlman

  • Posts: 212
Lee Valley drill press table and MFT stops!
« on: May 03, 2019, 01:18 PM »
Hi. Came across this today and it works great!
A friend asked me to make some new drawer fronts for a cabinet, so I was using one of the old ones for a template. Decided to use the drill press to drill handle holes rather than use my Kreg jig. I went to clamp some wood to the fence as per usual for stops, and had an idea to use some 1/4 20 bolts, knobs and cut some plywood  to make stops. I got out my 1/4 20 jig box and as I was searching thru it on my mft table......I noticed the stops on my mft
I had to add a washer under the knob as the bolt was bottoming out on the extrusion on the drill press table, and the stops are just a little too long to fold all the way down, but it worked great.

« Last Edit: May 03, 2019, 01:24 PM by gnlman »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.