Author Topic: Kapex support tables  (Read 4397 times)

0 Members and 1 Guest are viewing this topic.

Offline Maumee Mike

  • Posts: 11
Kapex support tables
« on: April 28, 2009, 08:56 PM »
Here is my Kapex Station that I have built.

Kapex saw with support and dust collection hood which I had fabricated by a sheet metal worker

Fence slides out so saw can tilt for compound angle cuts

Rear of sliding fence using toilet bolts and t knobs
« Last Edit: April 28, 2009, 09:11 PM by Maumee Mike »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Rey Johnson

  • Posts: 390
  • Fine Sawdust Maker
    • Festool MFT/TS55 Retrospective
Re: Kapex support tables
« Reply #1 on: April 30, 2009, 09:15 AM »
Maumee Mike,

Very cool setup. The sliding fence idea is great. Did you ever think of adding drawers into the sides of your table sides? I had a setup similiar to yours at one point and I made use of the space underneath the table.

I am working from a single car garage, so space is limited for me and every little nook and cranny is meaningful.

Very nice!