Author Topic: Homemade Mini MFT  (Read 6875 times)

0 Members and 1 Guest are viewing this topic.

Offline Wim

  • Posts: 286
Homemade Mini MFT
« on: May 18, 2007, 11:36 AM »
For handling small objects I needed a small tabletop with a smooth top and also clamping capacity.
So I made a scaled down version of a MFT.
I found a left-over from a sinktop, thickness 30 mm and about 500 x 700 mm with a melamine covering.
For holes I wanted the mortises of the Domino, than I had also sufficient dogs. The holes are for 10 x 50 Domino's. Drilling them was a piece of cake. For extra versatility, I oriented the mortises in two directions. From a few small clamps and some Domino's I made a clamping system. And for good measure I added a few accessories to clamp round parts.
The table is intended for modelling, woodcarving and glueing-up small parts. With this set-up I can take the table to the living room and enjoy my favorite music or even watch TV while "working".


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline ejantny

  • Posts: 182
  • Scotia, NY
Re: Homemade Mini MFT
« Reply #1 on: May 18, 2007, 12:14 PM »
Nicely done and a great mini mft. Who makes the clamps you are using?

Offline Wim

  • Posts: 286
Re: Homemade Mini MFT
« Reply #2 on: May 18, 2007, 12:34 PM »
The clamps are made by Wolfcraft, a German company. See their website at www.wolfcraft.de
There is an English version.

Offline ryansmythe

  • Posts: 38
Re: Homemade Mini MFT
« Reply #3 on: May 18, 2007, 05:56 PM »
looks good wim, how long did it take to make all the mortises?

Offline Wim

  • Posts: 286
Re: Homemade Mini MFT
« Reply #4 on: May 18, 2007, 06:05 PM »
It was not a contest so I did no time-keeping. I guess it was under 30 minutes, the drawing of the lay-out included.
The material was chipboard and I was surprised to see just a minimal amount of chip tear-out.

Offline Jim Marsh

  • Posts: 29
Re: Homemade Mini MFT
« Reply #5 on: May 18, 2007, 10:30 PM »
Great idea and well executed. It will go on my list as I am always doing something when I watch TV. Thanks.