Author Topic: HM D6/16-VS 600 490762 ??? Spiral groove cutter  (Read 482 times)

0 Members and 1 Guest are viewing this topic.

Offline Stimpy

  • Posts: 8
HM D6/16-VS 600 490762 ??? Spiral groove cutter
« on: November 29, 2020, 05:22 PM »
So I got an old VS600 a while back as it was a good price and just taken it out to investigate!.. I Got the SZO 14 templates with it and note that I have a 17mm ring and dovetail cutter with it but am missing the other ring and bit.

The other ring I can see is an 8.5 and these are readily available, but the spiral bit code registers no where! I assume it is just a spiral upcut bit 6mm x 16mm?. Also, if so, will a regular 6mm fluted bit do?

I don't have the the entering mandrel either ( for the 1010) but I guess I could make something perhaps...

Thanks

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Stimpy

  • Posts: 8
Re: HM D6/16-VS 600 490762 ??? Spiral groove cutter
« Reply #1 on: December 01, 2020, 05:30 AM »
Update...

Just spoke to my festool dealer in the UK and his book lists a different code than I found! He has 490978 which is a 6/21 8mm shank spiral cutter. He doesn’t know if it is an upcut or down cut but has one in stock for a vast sum!

Anybody out there got this system or could advise if an up or down cut would be more suitable in the jig? I guess as the copying ring is located for the most part when In use then a down cut would give a better a finish?..

Thanks..

Edit: So done some more googling as a bit quiet on here! It looks like the original code I have was on some of the earlier documentation - the references I found first!, and this updated code is now on some of the newer tech sheets / adds.

For future reference the item is a twin flute spiral 6mm/21mm with an 8mm shank now and is an upcut.
« Last Edit: December 01, 2020, 03:11 PM by Stimpy »