Author Topic: Had a thought for rail support  (Read 987 times)

0 Members and 1 Guest are viewing this topic.

Offline Bertotti

  • Posts: 196
Had a thought for rail support
« on: November 04, 2020, 08:40 PM »
I was looking at my table and when I use it I almost always cut in the same area. I was wondering if any thinks this might be a viable idea. We have the dog holed but where the rail actually sits I don’t use them so I was think route out a a strip and mount something through the dog holes that would raise a strip set in the routed channel up to support the rail when I do narrow cuts. Just a glimmer of and idea I may pursue.
I want to populate SD with trees because I miss the forests of the river bottoms.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline mkasdin

  • Posts: 475
Re: Had a thought for rail support
« Reply #1 on: November 10, 2020, 02:59 AM »
You might want to look at benchdogsUK they do b-collars for their bench dogs, similar to what you have in mind? You’re contemplating shim stock equal to the stock for fine width rippling for making useable off cuts in lieu of a table saw setup. That is a weak link when it comes to using the Festool track/saw for a few reasons that come to mind....