Author Topic: Festool Siding Jig  (Read 574 times)

0 Members and 1 Guest are viewing this topic.

Offline JD2720

  • Posts: 1096
Festool Siding Jig
« on: September 08, 2019, 08:35 AM »
I had 3 gables to put double 4 vinyl siding on, so I made a simple jig to use a TS55 & guide rail to cut the angles.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline cblanton42

  • Posts: 91
Re: Festool Siding Jig
« Reply #1 on: September 08, 2019, 10:18 AM »
Not picking on your work, but any idea what's causing those 3 bumps above the middle window?  I know vinyl doesn't dent so something is pushing it outward. 

Offline JD2720

  • Posts: 1096
Re: Festool Siding Jig
« Reply #2 on: September 08, 2019, 11:31 AM »
The bumps were from shipping. After the sun hits it they will go away.