Author Topic: Festool planer 65 jig  (Read 1715 times)

0 Members and 1 Guest are viewing this topic.

Offline Mavrik

  • Posts: 240
Festool planer 65 jig
« on: April 17, 2016, 10:03 AM »
I've got the Festool 65 planer.
It cuts amazingly well.

I want to use it inverted as a mini jointer.
I had the Festool jig.
But it was finicky and eventually just broke.

Has anyone else built this planer into a jig or table inverted to make it reusable as a mini jointer?

Sent from my SM-G920F using Tapatalk

TS55, MFT 1080, PS300, EHL 65, Domino, OF 1010, CTL 22, RO 125, BS75

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.